Thanks for the suggestion Dave -- but I'm afraid the result was the same.
I'm re-repeating the process and this time I'll also save the output from
configure in case that is enlightening...
On Fri, Feb 26, 2016 at 12:33 PM, David A Case <david.case.rutgers.edu>
wrote:
> On Fri, Feb 26, 2016, Brent Krueger wrote:
> >
> > Attached are stdout and stderr from running make install a second time
> > right after the first failure. Let me know if it would be more
> informative
> > to do a make clean and repeat from scratch.
>
> I've seen similar things, that were always fixed by "make uninstall"
> followed
> by ./configure and "make install". (Basically, the first step may be
> needed
> to force re-building of fftw3; "make clean" is probably not enough.)
>
> Re: the testing arguments we've been having: the test procedures check
> out a fresh source tree and build from scratch. Updates that somehow
> don't work as an incremental build don't get as much attention (at least
> from me.) This probably means that some dependency is not being properly
> checked. But finding out if if you can (or cannot) get a good build
> following the steps above would be very useful information.
>
> ....dac
>
>
> _______________________________________________
> AMBER-Developers mailing list
> AMBER-Developers.ambermd.org
> http://lists.ambermd.org/mailman/listinfo/amber-developers
>
--
_______________________________________________
Brent P. Krueger.....................phone: 616 395 7629
Professor.................................fax: 616 395 7118
Hope College..........................Schaap Hall 2120
Department of Chemistry
Holland, MI 49423
_______________________________________________
AMBER-Developers mailing list
AMBER-Developers.ambermd.org
http://lists.ambermd.org/mailman/listinfo/amber-developers
Received on Fri Feb 26 2016 - 11:00:03 PST
